I don’t understand why it’s so complicated -I’ve always thought that the whole point of Apple products was to make life simple for the user! Thanks. There is a very tiny button (?) which I have tried to push in with a paper clip but to no avail. Although supplies are dwindling, shoppers can still get their hands on an AirPort Express Base Station at Adorama for 95 with free shipping and no tax collected on orders shipped outside New York. To set up AirTunes on the AirPort Express Base Station (AX), either connect to the AXs wireless network or temporarily connect your computer directly (using an Ethernet cable) to the Ethernet port of the AX, and then, use the AirPort Admin Utility to check these settings: AirPort tab. You will need v6. They are designed to work with the family of 802.11n AirPort base stations: AirPort Extreme, AirPort Express, and Time Capsule. I’ve read that I need to reset the A Express unit but do not see how to do that. Port Mapping Setup (Note: These instructions will not work with the 802.11ac versions of the AirPort base stations. All I see is under Window the name of my new network. I tried Airport Help which tells me to select the device I wan to set up but I don’t see the device. I have also tried to set A Express to its default position but the software does not achieve this. I bought the AirPort Express (AX) on eBay as the lowest cost method of acquiring an Apple wireless base station. To identify the base station that is configured as a router, do the following: In the graphical overview, select a base station, then click Edit. Open the AirPort Utility app on your Mac, located in the Utilities folder in the Applications folder. After 10 minutes I get this: An error occurred while reading the configuration. If your network uses more than one base station, you can extend your guest network. It says Reading settings but the wheel spins endlessly. AirPort Utility v5.4.2 is the simple to use, setup and management utility for the AirPort Express Base Station, the AirPort Extreme Base Station, and Time Capsule. That will get the setup 'wizard' up and running. Click on AirPort Express under the listing of New AirPort Base Station. Click the WiFi icon at the top of your Mac. Using Airport Utility I entered -several times- the name and password of the new network but that information seems not to be retained i.e. Connect an Ethernet cable to the WAN 'O' port on the A1392 Express devices. My iMac (OS 10.7.5) is connected by cable to the router for internet access.Īirport Utility continually searches but states that No configured Airport Base stations have been found. Click 'Manual Setup' and enter your password if needed. The A Express unit is plugged into my hifi amplifier and is only used to stream audio wirelessly to the amp. Connect to the primary router with the Apple AirPort setup tool open, using the 'Base Station Chooser' in the setup program. I have just switched from BT to Virgin (cable) broadband but can no longer get Airport Express to work. ) NAT, DHCP, PPPoE, VPN Passthrough (IPSec, PPTP L2TP), DNS Proxy, SNMP, IPv6 (6to4 Manual Tunnels) 3.5.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |